This site has limited support for your browser. We recommend switching to Edge, Chrome, Safari, or Firefox.

Free shipping on USA orders over $100 - SEE DETAILS

Phil Wood sealed cartridge hub bearings

$ 10.00

Are the sealed bearings in your hubs crunchy and beat? Knock them out and replace them with buttery Phil Woodness.

We sell options that work in any sealed bearing hubs (not just Phil Wood) but be sure to get the right size!

6000, 6901 and 6902 available with stainless steel bearings, 6001 and R8 available with stainless steel or Carbonyte bearings.


Phil's Carbonyte bearings use a proprietary grease applied to provide protection against wear while allowing for the low rolling resistance you would expect from a ceramic bearing. Bearing seals are are not full-contact, so we do not recommend these bearings off road or wet/corrosive environments.

• sizes: 6000, 6001, R8, 6901, 6902

• inner/outer diameter/width: 26mm/10mm/8mm (6000); 28mm/12mm/8mm (6001); 28.5mm/12.7mm/8mm (R8) 24mm/12mm/6mm (6901), 28mm/15mm/7mm (6902)

• sold individually

• R8 bearings have seals that are as good or better than those found in the highest quality submersible motor and pump bearings

All modern front & rear Phil Wood track hubs use R8.

2nd generation (1978-1991) Phil track hubs, MIche Primato Pista and Suzue Pro Max SB use 6001.

Gran Compe, DT Swiss 370, Novatec and Formula track hubs use 6000.

Surly Ultra New uses 6901.

Paul Comp High Flange uses 6902.